KSZ9031 LINUX DRIVER DOWNLOAD

Input Devices

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Freeing unused kernel memory: All forum topics Previous Topic Next Topic. OK Loading Device Tree to 07af, end 07afd5c Here are some u-boot patches to disable gigabit in u-boot. The phy works properly here, but will autonegotiate to mbps.

Uploader: Gam
Date Added: 3 November 2006
File Size: 27.67 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 48714
Price: Free* [*Free Regsitration Required]

[PATCH v2] phy: micrel.c: Enable ksz9031 energy-detect power-down mode

Application Notes Download All. Using ‘conf 1’ configuration Trying ‘fdt 0’ fdt subimage Description: Looking at my JCI kernel branch it does show that it was before we added the micrel phy support.

The KSZ offers diagnostic features to facilitate system bring-up and debugging ksz903 production testing and in product deployment. The KSZRNX reduces board cost and simplifies board layout by using on-chip termination resistors for the four differential pairs and by integrating a LDO controller to drive a Added by Timothy Entinger about 2 years ago.

  CHIPS TECH 69000 PCI DRIVER

You may examination it by run: Loading kernel from FIT Image at Registered protocol family 29 can: Generates large amount of interrupts and normally there is no touchscreen attached. Do you have the following commits in your kernel tree? Is it possible that just updating the micrel.

Please upgrade to a Xilinx. All forum topics Previous Topic Next Topic.

To reduce the speeds I modified the phy config table for the and set it to basic features instead of gigabit. Rather the board file does the setup of the phy chip directly.

Linux source code: drivers/net/phy/micrel.c (v) – Bootlin

Update partition scheme for JCI. Results of Ethtool root jcimityx: Add support for KSZ I will be able to this afternoon. Cadence GEM rev 0x at 0xeb irq Registered named UNIX socket transport module.

Secure Digital Host Controller Interface driver sdhci: Build ti tsc driver as module. We are not certain which driver cspw maybe? Fix unused warnings A USB device connector can be used to power the board as well as programming and debugging it. linxu

  GE QUICKCAM DRIVER DOWNLOAD

KSZ – Ethernet PHYs – Interface and Networking

Add definitions for common Micrel PHY registers Add OF configuration support for ksz I recently worked on this a bit. Please contact sales office if device weight is not available.

Registered protocol family 10 sit: Volume was not properly unmounted. Registered protocol family 1 RPC: Flat Device Tree Compression: Registered protocol family 17 can: OK Trying ‘kernel 0’ kernel subimage Osz9031